Lifting Eye Bolt Drawing . Fig.1.eye bolt with integral wall anchor Hole sizes in pad eyes should be bored or drilled to provide a diameter equal to the shackle pin diameter plus 3mm or 4% greater than the shackle pin diameter, whichever gives the larger hole.
Nut Eye Bolt SP 1/2 RH x 2 CS SC G.L. Huyett from www.huyett.com
0.3 this specification covers eyebolts designed to use with shackles. Before lifting check the tightness of the eye bolt and nut! The eye bolt must be fully screwed in, achieving firm contact between the two mating faces.
Nut Eye Bolt SP 1/2 RH x 2 CS SC G.L. Huyett
Direction of pull adjusted working load Forged steel eyebolts grade 4 for general lifting purposes: 0.3 this specification covers eyebolts designed to use with shackles. Complies with the machinery directives 2006/42/eg;
Source: www.certex.dk
Forged steel eyebolts grade 4 for general lifting purposes: Special shank length part no. Assure a plane bolting surface. • if lifting eye bolts form part of lifting equipment, ce marking is necessary. Complies with the machinery directives 2006/42/eg;
Source: www.automotioncomponents.co.uk
Standard eye bolts are normally only able to be used for inline lifting operations. Direction of pull adjusted working load An eyebolt, also known as a lifting eye, is a bolt with a loop at one end. The following guidelines for din 580 lifting eye bolts must be observed in addition to the maximum load values given in the table:.
Source: www.ranger.com.au
Ensure the eye bolt is bolted down flush to the surface! Join the grabcad community today to gain access and download! Hole sizes in pad eyes should be bored or drilled to provide a diameter equal to the shackle pin diameter plus 3mm or 4% greater than the shackle pin diameter, whichever gives the larger hole. The steel grade used.
Source: www.ranger.com.au
Do not apply load across the face of the ring! The values given in the table are only applicable when the component attached to the ring is steel, cast steel, or cast iron, and is fastened securely to the mating surface. Also available in imperial and special threads. Before installing and every use, visually inspect rud lifting points, with particular.
Source: www.huyett.com
Join the grabcad community today to gain access and download! Angular lifting should be avoided. Assure a plane bolting surface. The following guidelines for din 580 lifting eye bolts must be observed in addition to the maximum load values given in the table: Fig.1.eye bolt with integral wall anchor
Source: www.ewdaniel.com
Avoid twisting movements during transport. 1.after the loads on the eye bolts have been calculated, select the proper size eye bolt for the job. Angular lifting should be avoided. An eyebolt, also known as a lifting eye, is a bolt with a loop at one end. Do not apply load across the face of the ring!
Source: www.huyett.com
The counter thread must be of an equal length and the base material of an equal strength to that of the bolt. The eyebolt has a threaded shank or rod which is securely screwed into a structure. • lifting eye bolt do not require ce marki ng if not used for lifting (as towing eyes fo r example) or is.
Source: www.huyett.com
When an appropriate hook is attached to the swivel eye and the load's forces are applied the link will swivel and tilt into the direction of the pulling action. Create your own lifting eye by adding an eye nut to a stud or bolt. Hole sizes in pad eyes should be bored or drilled to provide a diameter equal to.
Source: www.huyett.com
For angular lifts, adjust working load as follows: 0.3 this specification covers eyebolts designed to use with shackles. Forged steel eyebolts grade 4 for general lifting purposes: Before lifting check the tightness of the eye bolt and nut! Direction of pull adjusted working load